Invacare R2-250, Pronto R2 manual O N T I N G

FRONT RIGGINGS PROCEDURE 3

ADJUSTING THE CALF-PAD DEPTH USING THE DIRECT MOUNT METHOD (FIGURE 22).

1.Removethecalf-pads.RefertoREMOVING/INSTALL- INGTHECALFPADSinthisprocedure of the manual.

2.Remove the center mounting screw, nylon spacer, small washer, and locknut that secure the calf-pad bracket to the pivot bracket.

3.Remove the other mounting screw and locknut that secure the calf-pad bracket to the pivot bracket.

4.Perform STEPS 1-3 for other calf-pad mounting bracket.

5.Remove the two (2) hub caps from the pivot bracket.

6.Remove the mounting bolt, two (2) caplug wash- ers, two (2) large washers and locknut that se- cure the pivot bracket to the legrest tube.

NOTE: Save the pivot bracket and attaching mount- ing hardware from STEPS 2-6 for future use. Securely tighten.

7.Position the calf-pad brackets on the legrest tube in the desired orientation. Refer to FIGURE 22.

8.Secure the calf-pad brackets to the legrest tube with the two (2) 5/16-24 x 3-inch long mounting screws, washers and locknuts in the orientation determined in STEP 7.

9.Install the calf-pads. Refer to REMOVING/INSTALL- INGTHECALFPADSinthisprocedure of the manual.

F R O N T

R

I

G G I N G

	Center	Mounting Screw
		Calf-Pad Bracket
Nylon Spacer	Mounting
	Screw

Legrest

Calf-PadTube Hub Cap

Bracket

	Pivot
	Bracket	Mounting Bolt
	Large Washer
Small	Caplug Washer
Locknuts Washers		Caplug Washer
	Locknut	Large Washer
	Hub Cap

S

CALF-PAD BRACKETS IN FORWARD MOUNT

POSITION

CALF PAD-BRACKETS IN REVERSE MOUNT POSITION

5/16-24 x 3-inch Calf-Pad Mounting Screws Bracket

Calf-Pad

Bracket

Washer

Locknuts

Washer

SIDE VIEW

Calf-Pad

Legrest

Tube

SIDE VIEW

Calf-Pad

Legrest

Tube

FIGURE 22 - ADJUSTING THE CALF-PAD DEPTH - DIRECT MOUNT METHOD

25