Invacare R2-250, Pronto R2 manual REMOVING/INSTALLING the CALF-PADS Figure, Adjusting the CALF-PADS

FRONT RIGGINGS PROCEDURE 3

SIDE VIEW OF 90O FOOTBOARD

Flat Head Screws

(Loosen Here)

Pivot Hinge

Half Clamp Barrel Nuts

REMOVING/INSTALLING THE CALF-PADS (FIGURE 16)

NOTE: Instructions apply to removing the calf-pads. To install the calf-pads, reverse the following steps.

1.Remove the one piece footboard from the chair. Re- fer to INSTALLING/REMOVING THE ONE PIECE FOOTBOARD in this procedure of the manual.

2.Remove the two (2) phillips head screws and wash- ers that secure the calf-pad to the calf-pad bracket.

3.Repeat for other calf-pad if necessary.

F R O N T

R

I

G G

FIGURE 14 - ADJUSTING THE FOOTBOARD ANGLE

Depth (FIGURE 15)

1.Remove the four (4) flat head screws and barrel nuts that secure the footboard to the two (2) half clamps.

NOTE: The footboard depth may also be adjusted by rotating the half clamp 180o.

2.Position the footboard on the two (2) half clamps at the desired mounting position.

3.Install the four (4) flat head screws and barrel nuts through the footboard and two (2) half clamps. Securely Tighten.

Flat Head

Screws

Heel

Mounting

Holes

Footboard

Half Clamp mounting	Barrel Nuts
positions

WARNING

DO NOT use these mounting hole posi- tions with the half clamp in this orienta- tion, otherwise injury and/or damage may result.

Calf-Pad

Calf-Pad Bracket

Washer

Phillips Head

Screws

FIGURE 16 - REMOVING/INSTALLING CALF-PADS

ADJUSTING THE CALF-PADS

NOTE: Some calf-pad adjustments may require the removal of the one piece footboard. Refer to REMOV- ING THE ONE PIECE FOOTBOARD in this procedure of the manual.

Adjusting the Calf-Pad Height (FIGURE 17)

1.Remove the calf-pads. Refer to REMOVING/IN- STALLING THE CALF-PADS in this procedure of the manual.

2.Remove the two (2) hub caps from the pivot bracket.

3.Remove the mounting bolt, locknut, two (2) caplug washers and two (2) large washers that secure the pivot bracket to the legrest tube.

NOTE: DO NOT cover the warning label on the legrest tube shown in FIGURE 17.

4.Slide the calf assembly up or down to the desired position on the legrest tube.

5.Secure pivot bracket to the legrest tube with the mounting bolt, (2) caplug washers and two (2) large washers and locknut. Securely tighten.

6.Replace the two (2) hub caps over the caplug wash- ers.

7.If necessary, replace the one piece footboard. Re- fer to INSTALLING THE ONE PIECE FOOTBOARD in this procedure of the manual.

I

N G S

FIGURE 15 - ADJUSTING THE FOOTBOARD ANGLE/DEPTH

21