Omega DP26-RTD manual Main Power Connections dc powered unit, Analog and Relay Output Connections

Page 26

3.5 CONNECTING MAIN POWER (Continued)

Connect the dc main power connections as shown in Figure 3-9..

Figure 3-9 Main Power Connections (dc powered unit)

3.6 ANALOG AND RELAY OUTPUT CONNECTIONS

If you have purchased a meter with analog or dual relay or isolated analog output, refer to the following figures for output connections.

Figure 3-10 Relay Output Connections

18

Image 26

Contents User’s Guide Servicing North America Standard Procedures PrefacePage Iii Table of Contents Selecting Output Configuration OT.CF List of Figures Introduction UnpackingSafety Considerations EMC ConsiderationsDescription Standard FeaturesAbout the Meter Available Accessories Add-On OptionsFront of the Meter Shows the location of each part of the front of the meterMeter Buttons Setpts ButtonReset Button Front Panel Lockout Push Button Lockout Jumper LockoutConnector label ac Powered and dc Powered detail Back of the MeterBack of the Meter Connector Description Disassembly Disconnect the power supply before proceedingRATING/PRODUCT Label Main Board Power JumpersGetting Started Main Board Jumper Positions S3 Jumper Functions Mounting the Meter PlcsConnecting Sensor Input Through 3-7 illustrate how to connect you power sensorsConnecting Main Power Main Power Connections ac powered unitMain Power Connections dc powered unit Analog and Relay Output Connections11 Analog Output Connections Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Display /DEV Reset DescriptionMenu /DEV Setpoint Configuration Displays SetpointSpecifications Signal InputInput Power Information Analog Output if applicable Side View TOP View Factory Preset Values Menu Item Factory Preset ValuesCE Approvals Information WARRANTY/DISCLAIMER OMEGA…Of Course