Omron Healthcare HBF-500 instruction manual Error Indicators, Error Display Cause Correction

ERROR INDICATORS

ERROR DISPLAY	CAUSE	CORRECTION
		Make sure you are barefoot.
		Make sure your palms or the soles of
	Your palms or feet are not positioned	your feet are clean and dry.
		Make sure your feet are correctly
	over the electrodes correctly.
		positioned.
		Read “How to Take a Measurement”
		on page 26.
	The measurement position was not	Remain still and do not move until the
	stable.
		measurement is complete. Read “How
	Your palms or feet were not placed
		to Take a Measurement” on page 26.
	correctly.
		Slightly moisten the soles of your feet
	Feet are too dry.	with a damp towel and retake the
		measurement.
		Check the settings entered for your
		personal data. Change the settings
	The Body Composition values are	if needed. Retake the measurement.
	outside the measurement range.	If this error occurs again and the
		settings are correct, measurements
		cannot be taken.
	Your palms or feet are not positioned	Make sure your palms or feet are
	over the electrodes correctly.	correctly positioned.
		Remove the batteries. Wait one minute.
		Reinstall the batteries. Refer to “Battery
	The monitor is not set up correctly.	Installation” on page 18.
		Press the Power Switch and turn the
		monitor on. Retake the measurement.
	You stepped onto the measurement	Wait until 0.0 lb is displayed before
		stepping onto the measurement
	platform before 0.0 lb was displayed.
		platform.
	The monitor was moved before 0.0 lb	Do not move the monitor until 0.0 lb is
	was displayed.	displayed.
	Movement during measurement.	Do not move until measurement is
		complete.
	Monitor detected weight over 300.0 lb.	This monitor can only be used by
		people weighing less than 300.0 lb.

37