Pelco manual Pelco Manual C1977M-D 6/02

1.Connect a PV130 Converter to the RS-232 port on the front of the PelcoNet Transmission System receiver. The data format should be 4800 baud, 8 data bits, no parity, and 1 stop bit.

2.Connect the black and white striped wire from the power supply that comes with the converter to the converter’s +12 VDC terminal and the solid black wire to the GND terminal.

3.Connect RD(A) on the converter to terminal 2 on the wall block. Connect RD(B) on the converter to terminal 1 on the wall block.

4.Connect a 12 VAC power supply to terminals 3 and 4 on the wall block.

5.Set the DIP switches on the KBD300 for Direct Mode (switches 1-4 and 7-8 OFF, switch 5 ON). Set switch 6 ON to enable turbo pan operation or OFF to disable the turbo feature.

6.Connect the wall block to the KBD300 with an RJ-45 straight cable.

7.Connect the monitor.

8.Repeat steps 1 and 2 for the transmitter.

9.Connect TD(A) on the converter to the RX- terminal on the Spectra or receiver. Connect TD(B) to the RX+ terminal on the Spectra or receiver. Use P protocol only.

10.Connect the camera video to the transmitter.

Pelco Manual C1977M-D (6/02) [ 71 ]