Pelco C1977M-D manual Connecting a Pelconet Transmitter To The CM6800 Ascii Port

Connecting a Pelconet Transmitter To The CM6800 ASCII Port

Refer to Figure 51. This configuration lets an operator view and control cameras with a PC using a web browser. (The operator’s PC is not shown on the diagram.) All settings are done in the CM6800 manager program or through a CM6800 menu. Note the following:

•Port 2 defaults to ASCII and RS-232.

•Ports 7 and 8 can be set to ASCII and RS-232 by using the CM6800 manager program (refer to Figure 51) or by using a CM6800 menu (refer to Figure 52).

Pelco recommends using Port 2.

CM6800-48X8

PORTSETUP	PROTOCOL
CM6800ASCII	®
	COAXITRON
PELCONET	SPECTRA

00669

6800MATRIXCOM2 PORTSETTINGS:		BAUDRATE 9600 DATABITS 8 PARITY ODD STOPBIT 1
	PELCONETCM6800-48X8	TRANSPARENTDATAPORT COM2 2RXD...................................................8TXD 3TXD...................................................1RXD 5GND..................................................5GND	CONNECTPELCONETTO6800VIARS-232PORT

PelcoNet with CM6800 to Provide Remote Control

VIDEOIN	PELCONET TRANSMITTER	CONTROL TERMINAL	3-TX I/OALARM	TRANSPARENTDATAPORT	INTERNETUSINGEXPLORER, TRANSPARENTSET DATA SETTINGS:PORT RATEBAUD9600 BITSDATA8 RITYPAODD BITSTOP1
		RX2-	GND5-
TONETWORK(LAN/WAN)

Figure 51. Using

Pelco Manual C1977M-D (6/02) [ 85 ]