Pelco C1977M-D manual Pelconet Remote KBD200 Ascii Mode Setup

Connecting PelcoNet To a CM6800 and KBD200 For Remote ASCII Control

Refer to Figure 54. This configuration lets an operator view and control cameras with a remote KBD200 keyboard. All settings are done in the CM6800 manager program or through a CM6800 menu. Note the following:

•Port 2 defaults to ASCII and RS-232.

•Ports 7 and 8 can be set to ASCII and RS-232 by using the CM6800 manager program (refer to Figure 52) or by using a CM6800 menu (refer to Figure 53).

Pelco recommends using Port 2.

PELCONET REMOTE KBD200 ASCII MODE SETUP

STRAIGHT CABLE SUPPLIED

RJ-45 WALL BLOCK AND

TD(B)	TD(A)	8	RD(A)	RD(B)	ORDEREDPV130SEPARATELY
			1
		7	2
		6	3
		5	4
			TD(A)
			TD(B)
			GND
			+12 VDC

	GND	12V	PV130
VIDEOOUT		2-RX	3-TX	5-GND	TRANSPARENTDATAPORT
	PELCONET RECEIVER	CONTROL TERMINAL		ALARMI/O

TO NETWORK (LAN / WAN)

KBD200	FIRMWAREVER.4.0ORLATERREQUIRED.	SETKEYBOARDDIPSWITCHES-SWITCH 6ON,SWITCHES5AND8OFF,SWITCHES	1-4FORADDRESSACCORDINGTOTHE	TABLEINTHEKBD200MANUAL.
	NOTE:
	PROTOCOL			12VAC
	®
	SPECTRACOAXITRON
USINGINTERNETEXPLORER,	SETTRANSPARENTDATASETTINGS	ONBOTHPELCONETRECEIVERAND TRANSMITTER:	BAUDRATE 9600	DATABITS 8 PARITY ODD STOPBIT 1

CM6800-48X8

VIDEOIN	PELCONET TRANSMITTER	2-RX	3-TX	5-GND
		CONTROL TERMINAL		ALARMI/O
TONETWORK(LAN/WAN)

00668

6800MATRIXCOM2 PORTSETTINGS:		BAUDRATE 9600	DATABITS 8	PARITY ODD	STOPBIT 1
	CM6800-48X8	COM2 8TXD		1RXD	5GND
	PELCONET	TRANSPARENTDATAPORT	2RXD	3TXD	5GND

TRANSPARENT DATA PORT

CONNECT PELCONET TO 6800 VIA RS-232 PORT

Figure 54. Using PelcoNet with CM6800 and KBD200 to Provide Remote Control

Pelco Manual C1977M-D (6/02) [ 87 ]