Panasonic MC-UG775 manuel dutilisation Replacing Belt

Page 34

Replacing Belt

Lift Agitator Up

Soulever l’agitateur

Unidad del agitador

Motor Shaft

Arbre d’entraînement du moteur

Eje del motor

Slide Arch

Arc glissant

Aarco deslizante

➢Replace belt whenever a burning rubber smell caused by excessive belt slippage occurs.

➢Remove lower plate. See: “Removing and Installing Lower Plate”

➢Remove agitator by carefully lifting out.

➢Remove worn or broken belt.

➢Clean agitator. See: “Cleaning Agitator”

➢Loop new belt (Panasonic Type UB8 only) around motor shaft and agitator pulley; see illustration for correct belt routing.

End Cap
Bouchon
Tapa de
extremo
Groove
Ouverture
Ranura
Slide Arch
Arc glissant
Aarco deslizante	Groove
	Ouverture
	Ranura

➢Reinstall slide arch into the agitator end cap.

➢Reinstall agitator back into nozzle housing grooves.

➢After reinstalling the agitator, turn it by hand to make sure the belt is not twisted or pinched and that all rotating parts turn freely.

➢Reinstall lower plate. See: “Removing and Installing Lower Plate”

- 34 -

Image 34

Contents Vacuum Cleaner MC-UG775To OUR Valued Customer Please PAY Close Attention to ALLRenseignements importants Notre ClientèleAdvertencia Cuidado Important Safety Instructions Avertissement Instrucciones importantes de seguridad Table of Contents Table des matières Tabla de contenidoParts Identification Identificación de piezasFeature Chart Tableau des caractéristiquesAssembly Attaching HandleMontage du manche Colocación del mangoUsing Cord Hook Tool StorageUso del sujetador del cordón Rangement des accessoiresCrochet de rangement du cordon Almacenaje de herramientasAutomatic Self Adjusting Nozzle FeaturesCarpet-Bare Floor Selector Boquilla de ajuste automático AvertissementTête d’aspiration autoréglable Sélecteur tapis/plancherThermal Protector Motor ProtectorProtecteur du moteur Protecteur thermiqueProtector termal Protector de motorEdge Cleaning Performance IndicatorLimpieza para orillas Nettoyage latéralIndicateur de performance Indicador del funcionamientoTo Operate Vacuum Cleaner Power Cord ON-OFF SwitchCordón eléctrico CuidadoCordon d’alimentation InterrupteurHandle Adjustments Tool UsageAjustes del mango Utilisation des accessoiresRéglage de l’inclinaison du manche Uso de herramientasReplacing Hepa Filter Routine Care of Vacuum CleanerReplacing Secondary Filter Cambiando el filtro Hepa Remplacement du filtre De type HepaRemplacement du filtre Secondaire Cambiando el filtro secundarioChanging Dust Bag Remplacement du sac à poussière Cambio de la bolsa para polvoRemoving and Installing Lower Plate Enlèvement et installation de la Plaque inférieure Remover y reinstalar la base inferiorReplacing Headlight Bulb Remplacement de l’ampoule De la lampe Cambio de la bombillaReplacing Belt Remplacement de la courroie Cambio de la correaCleaning Agitator Cleaning Exterior and ToolsLimpieza del agitador Nettoyage du boîtier et des AccessoiresNettoyage de l’agitateur Limpieza del exterior y de las HerramientasRemoving Clogs Dégagement des obstructions Limpiar los residuos de basura en los conductosBefore Requesting Service Guide de dépannage Antes de pedir servicio Warranty Panasonic Platinum Series Vacuum Cleaner Limited WarrantyPanasonic Platinum Series Vacuum Cleaner Limited WarrantyGarantie Panasonic de la série PlatinumGarantía Page What to do When Service is Needed What to do when service is needed Service après-vente Canada