DOME DRIVE
CAUTION: Make sure the dome drive locks into
place. Tug downward on the dome drive with moderate pressure to ensure that it stays in place.
1.Turn on power to the back box. The red LED should light to indicate power.
If the LED does not light, correct the trouble before proceeding. Refer to the Trouble- shooting section.
If the light is operating, you may either leave the power on and continue with the installation, or you may turn the power off before proceeding further.
2.Set the switches on the bottom of the dome drive. Refer to Figure 14 and Table C for the settings for SW1.
Refer to Figure 14 and Tables D and E for the settings for SW2.
3.Install the dome drive in the back box: Line up the green drive eject tab on the dome drive with the green label on the back box and the red static tab with the red label on the back box. Raise the dome drive into the back box and push on the ends of the tabs until they both click into place on the back box.
4.Turn on power, if it is not on. Listen for the fan operating. If the fan does not work, the dome will overheat and shut down. If the fan does not work, return the back box electronic assembly and dome drive to the factory for repair. Refer to the Back Box Electronic Assembly Removal section.
Proceed to the Lower Dome section.
SW 1
ON
1 2 3 4 5 6 7 8 OFF
ON
1 2 3 4 5 6 7 8 OFF SW 2
SW 1
ON
1 | 8 OFF |
ON
18 OFF
SW 2
Figure 14. Switch Locations
Table C. Switch Settings for SW1
Control Type |
|
|
| Switch Setting |
|
|
| |
| ||||||||
|
|
|
|
|
|
|
|
|
Coaxitron® | OFF | OFF | OFF | OFF | OFF | OFF | OFF | OFF** |
ON | OFF | OFF | OFF | OFF | OFF | OFF | OFF** | |
OFF | ON | OFF | OFF | OFF | OFF | OFF* | OFF** | |
NOTES: Switches SW
ON- Use with American Dynamics controllers (32 presets).
** OFF - Use with all control systems except CM9502 with variable speed keyboards. For CM9502 with fixed speed keyboards, set switch OFF.
ON - Use with CM9502 with variable speed keyboards for smoother joystick control.
Pelco Manual | 15 |