AT&T Not Availab installation instructions Headset jacks on the side of the Callmaster

Page 13

Headset

Jacks

FIGURE 2 The headset jacks on the side of the CALLMASTER

On both sides of the CALLMASTER (II and III) voice terminals, as shown in Figure 2 above, there is a set of headset jacks. Use these jacks for connecting a headset to your CALLMASTER set.

NOTE: Two headsets plugged into the sides of the CALLMASTER can be used simultaneously.

If any adjunct is active, the left and right headset jacks on the voice terminal are deactivated.

7

Image 13

Contents Definity AT&T 555-015-168 Comcode 107319659 Issue 1, AugustTo Order Copies of this Document WarrantyInterference Warning Information Part 15 of FCC Rules Hearing AID CompatibilityImportant Safety Instructions Service Contents Headset or the Handset Your Callmaster Voice TerminalOrganization of this Guide Recorder InterfaceConventions Callmaster Feature DescriptionsPage To initiate a self-test of your voice terminal Headset jacks on the side of the Callmaster Checklist of Parts InstallationComcode Orderable EquipmentConnecting the Line and Optional Equipment Cords Installing the Callmaster Voice TerminalsLine jack, adjunct jack, and routing channels Important Notes on InstallationDCP Line Interface Connector Block DCP Jack InterfacePage Callmaster Labeling and Installing the BUTTON-DESIGNATION Strips Testing the Headset or HandsetInserting the designation strips Raising or Lowering Receive Volume Feature ProceduresTo raise or lower the receive volume Going OFF-HOOKDisconnecting from Calls To add another party to an existing call ConferenceHold DropMute Select Ring and Ringer VolumeTo prevent the other party from hearing you To select a personalized ringSELF-TEST To adjust ringer volume if necessaryTo test the lights and ringer of your voice terminal Transfer Power Requirements Physical Dimension and WeightTechnical Description Environmental Requirements