AT&T Not Availab installation instructions

Page 19

Figure 4 shows how a CALLMASTER II with Recorder Interface should be configured through the wall jack with the DEFINITY PBX, an adjunct power source, and the recording device.

NOTE: Typically, a 104A wall jack is used in this type of configuration.

13

Image 19

Contents Definity AT&T 555-015-168 Comcode 107319659 Issue 1, AugustTo Order Copies of this Document WarrantyInterference Warning Information Part 15 of FCC Rules Hearing AID CompatibilityImportant Safety Instructions Service Contents Headset or the Handset Your Callmaster Voice TerminalOrganization of this Guide Recorder InterfaceConventions Callmaster Feature DescriptionsPage To initiate a self-test of your voice terminal Headset jacks on the side of the Callmaster Checklist of Parts InstallationComcode Orderable EquipmentConnecting the Line and Optional Equipment Cords Installing the Callmaster Voice TerminalsLine jack, adjunct jack, and routing channels Important Notes on InstallationDCP Line Interface Connector Block DCP Jack InterfacePage Callmaster Labeling and Installing the BUTTON-DESIGNATION Strips Testing the Headset or HandsetInserting the designation strips Going OFF-HOOK Feature ProceduresRaising or Lowering Receive Volume To raise or lower the receive volumeDisconnecting from Calls To add another party to an existing call ConferenceHold DropTo select a personalized ring Select Ring and Ringer VolumeMute To prevent the other party from hearing youSELF-TEST To adjust ringer volume if necessaryTo test the lights and ringer of your voice terminal Transfer Environmental Requirements Physical Dimension and WeightPower Requirements Technical Description