AT&T Not Availab installation instructions Callmaster

Page 20

PBX

Adjunct Power

Recording

Device

Twisted Pair

Wire

W-O (0D1) O-W (0D2) W-G (ID1) G-W (ID2) W-BR (P1-) BR-W (P2+)

W-BL (REC1)

BL-W (REC2)

White Connecting Block,

110-Type

4-Pair Cross

Connect

Blue Connecting

Block, 110-Type

House Cable

104A Wall

Jack

D8W Cord

CALLMASTER

CALLMASTER

Voice

Terminal

FIGURE 4 Connecting the CALLMASTER II with Recorder Interface to the PBX, adjunct power source, and the recording device

14

Image 20

Contents AT&T 555-015-168 Comcode 107319659 Issue 1, August DefinityWarranty To Order Copies of this DocumentHearing AID Compatibility Interference Warning Information Part 15 of FCC RulesImportant Safety Instructions Service Contents Your Callmaster Voice Terminal Headset or the HandsetRecorder Interface Organization of this GuideConventions Feature Descriptions CallmasterPage To initiate a self-test of your voice terminal Headset jacks on the side of the Callmaster Installation Checklist of PartsOrderable Equipment ComcodeInstalling the Callmaster Voice Terminals Connecting the Line and Optional Equipment CordsImportant Notes on Installation Line jack, adjunct jack, and routing channelsConnector Block DCP Jack Interface DCP Line InterfacePage Callmaster Testing the Headset or Handset Labeling and Installing the BUTTON-DESIGNATION StripsInserting the designation strips Feature Procedures Raising or Lowering Receive VolumeTo raise or lower the receive volume Going OFF-HOOKDisconnecting from Calls Conference To add another party to an existing callDrop HoldSelect Ring and Ringer Volume MuteTo prevent the other party from hearing you To select a personalized ringTo test the lights and ringer of your voice terminal To adjust ringer volume if necessarySELF-TEST Transfer Physical Dimension and Weight Power RequirementsTechnical Description Environmental Requirements