AT&T Not Availab Important Notes on Installation, Line jack, adjunct jack, and routing channels

Page 17

Line Cord	LINE Jack	Adjunct Jack	Adjunct Jack
Routing			Routing
Channel			Channel

FIGURE 3 The LINE jack, adjunct jack, and routing channels

Important Notes on Installation

The total distance between the CALLMASTER II voice terminal with Recorder Interface and the recording device should not exceed 200 feet.

The distance between the CALLMASTER II or CALLMASTER III voice terminal and the PBX must NOT exceed the following:

In 4-wire mode, with 22-gauge or 24-gauge wire, the distance between the CALLMASTER II or CALLMASTER III and the PBX should not exceed 5,000 feet; with 26-gauge wire, the distance should not exceed 4,000 feet.

In 2-wire mode, which is applicable only to the CALLMASTER III, with 22-gauge wire, the distance between the CALLMASTER III and the PBX should not exceed 5,500 feet;

with 24-gauge wire, the distance should not exceed 3,500 feet; with 26-gauge wire, the distance should not exceed 2,200 feet.

The record output impedance is approximately 600 ohms and the output channel is isolated from the voice terminal with an FCC Part 68-approved voice transformer.

11

Image 17

Contents Definity AT&T 555-015-168 Comcode 107319659 Issue 1, AugustTo Order Copies of this Document WarrantyInterference Warning Information Part 15 of FCC Rules Hearing AID CompatibilityImportant Safety Instructions Service Contents Headset or the Handset Your Callmaster Voice TerminalOrganization of this Guide Recorder InterfaceConventions Callmaster Feature DescriptionsPage To initiate a self-test of your voice terminal Headset jacks on the side of the Callmaster Checklist of Parts InstallationComcode Orderable EquipmentConnecting the Line and Optional Equipment Cords Installing the Callmaster Voice TerminalsLine jack, adjunct jack, and routing channels Important Notes on InstallationDCP Line Interface Connector Block DCP Jack InterfacePage Callmaster Labeling and Installing the BUTTON-DESIGNATION Strips Testing the Headset or HandsetInserting the designation strips Raising or Lowering Receive Volume Feature ProceduresTo raise or lower the receive volume Going OFF-HOOKDisconnecting from Calls To add another party to an existing call ConferenceHold DropMute Select Ring and Ringer VolumeTo prevent the other party from hearing you To select a personalized ringTo test the lights and ringer of your voice terminal To adjust ringer volume if necessarySELF-TEST Transfer Power Requirements Physical Dimension and WeightTechnical Description Environmental Requirements