Feature Procedures, Going OFF-HOOK | AT&T Not Availab specs

Feature Procedures

The following features can be used immediately. The procedures in this section give short, step-by-step instructions for using each of these features. For your convenience, beginning with the Conference feature, the features are listed alphabetically.

GOING OFF-HOOK

When the headset or handset is plugged into the terminal, it is immediately off-hook.

RAISING OR LOWERING RECEIVE VOLUME

You can use the Volume control button to raise and lower the receive level volume under the following conditions:

The CALLMASTER voice terminal is off-hook, and the headset(s) is plugged in.

The voice terminal is not off-hook on an external speakerphone call.

No call is ringing.

You are not in the midst of selecting a personalized ringing pattern.

To raise or lower the receive volume

To raise the volume of the receive level of the headset or the handset, press the right half of the volume control button

labeled ;

To lower the receive level of the headset or the handset, press the

left half of the volume control button labeled

NOTE: There are eight possible volume settings. Each press of the volume control button raises or lowers the volume one incremental level.

As you raise or lower the headset volume level, the display reflects your choice, such as:

Headset L > > > > H

On the display, one arrow is the lowest setting, and eight arrows is the highest setting.

NOTE: For procedures to raise and lower the ringer volume on your CALLMASTER set, see the procedures for the Select Ring feature later in this section.