AT&T Not Availab installation instructions Installing the Callmaster Voice Terminals

Orderable Equipment (continued)
ITEM	COMCODE
Handset D-Kit #182835 (white)	107318438
Handset cradle *	847278603
Thumbscrew *	847278611
Handset K2G2 *	107244352
Handset cord H4DU *	105635429
PJ327 Adapter *	407128354
Power module KS22911 L2	405331711
400B2 Adapter	104152558
Power cord (7-foot 2-pronged D6AP87 modular cord)	102937620

*This piece of equipment comes with the Handset D-Kit, but it can also be ordered separately with the Comcode in the second column.

INSTALLING THE CALLMASTER VOICE TERMINALS

Note: Use the following directions for installing both the CALLMASTER II and the CALLMASTER III voice terminals. The CALLMASTER voice terminal cannot be wall-mounted.

Connecting the Line and Optional Equipment Cords

See Figure 3 for the location of the jacks mentioned below.

1Lay the voice terminal face down so the bottom slopes toward you.

2Plug the line cord into the line cord jack. Press firmly until you hear the line cord click.

3Press the line cord into the line cord routing channel, placing the cord under the tab, and gently pull any slack from the cord to the rear of the voice terminal.

4Turn the voice terminal rightside up so that the faceplate is facing you.

5Plug the line cord into the modular wall jack. (Since the line cord is 7-feet long, your CALLMASTER voice terminal must be within this distance from the wall jack.)

NOTE: You may also use a 14-foot line cord. To order this cord, see ‘‘Orderable Equipment’’ earlier in these instructions.

10