AT&T Not Availab installation instructions Testing the Headset or Handset

Page 21

TESTING THE HEADSET OR HANDSET

1If you are using a handset, use the installation instructions that come with the handset kit to install the handset cradle.

2Plug in the headset or the handset, press a call appearance button, and listen for dial tone.

If you do not hear dial tone, press another call appearance button. You may also want to check that the cords are connected securely at both ends.

LABELING AND INSTALLING THE BUTTON-DESIGNATION STRIPS

1Make sure that the voice terminal is right side up.

2Type or write the numbers/features on the button designation strips with the appropriate button information.

3Crease the perforated edges of the button designation strips and then tear out the button designation strips.

4Install the strips by sliding them down into the correct button column slots, as shown in Figure 5.

15

Image 21

Contents Definity AT&T 555-015-168 Comcode 107319659 Issue 1, AugustTo Order Copies of this Document WarrantyInterference Warning Information Part 15 of FCC Rules Hearing AID CompatibilityImportant Safety Instructions Service Contents Headset or the Handset Your Callmaster Voice TerminalOrganization of this Guide Recorder InterfaceConventions Callmaster Feature DescriptionsPage To initiate a self-test of your voice terminal Headset jacks on the side of the Callmaster Checklist of Parts InstallationComcode Orderable EquipmentConnecting the Line and Optional Equipment Cords Installing the Callmaster Voice TerminalsLine jack, adjunct jack, and routing channels Important Notes on InstallationDCP Line Interface Connector Block DCP Jack InterfacePage Callmaster Labeling and Installing the BUTTON-DESIGNATION Strips Testing the Headset or HandsetInserting the designation strips Raising or Lowering Receive Volume Feature ProceduresTo raise or lower the receive volume Going OFF-HOOKDisconnecting from Calls To add another party to an existing call ConferenceHold DropMute Select Ring and Ringer VolumeTo prevent the other party from hearing you To select a personalized ringTo adjust ringer volume if necessary SELF-TESTTo test the lights and ringer of your voice terminal Transfer Power Requirements Physical Dimension and WeightTechnical Description Environmental Requirements