Oricom M5500 Series manual Installation and Charger, Tip

Page 8

GETTING STARTED

Installation and Charger

1. Connect the mains adaptor to the socket on the back of the base unit and to the wall mains supply.

AC110~240V

2. Connect the telephone cord to the phone socket on the back of the base unit and to the wall phone socket.

3. Insert 2 rechargeable Ni-MH AAA batteries (included), observing the correct polarity, into the battery compartment on the handset. Slide the battery door ﬁrmly into place.

4. Place the handset on the charging cradle and charge the batteries for a full 15 hours before using it for the ﬁrst time.

Note: It may take some time for the cordless handset to power up, and it may get warm during initial charge. This is normal.

Tip!

It is good practice to put the cordless handset on the charging cradle when it is not in use to ensure that the handset is always fully charged.

6

Image 8

Contents User Guide Keep this user guide for Future referencePage Contents LNR Function Last Number Redial ………………………………………… Cordless Handset Operation ………………………………………………… Adaptor for Charger Purchasing additional handsets Pack contentsGetting Started Installation and Charger TipYour cordless handset Understanding the cordless handset display Your M5500 base unit OK / Menu Down / OGM ANSDirect memory keys Dial Stop / On/Off / ESC Play / Pause / MuteUnderstanding the base unit display Answering an incoming call Basic OperationDuring standby Mute feature Making an external callNormal dialling Pre-diallingRecall feature Recall function when connected to a PabxCall waiting Take two different calls at the same timeGroup listening with base unit Pause feature when using on a PabxSwitching between Handset / Speaker mode with base unit Handsfree mode with cordless handset Volume adjustment with base unitSpeaker volume control Handset volume controlHow to enter names Direct MemoriesStore new records Press M1 / M2Key lock Edit / Dial / Delete stored recordsCaller ID Operation Review Caller ID recordsDial a CID number Store a CID numberDelete all viewed CID records Delete one or all CID recordsDelete one CID record Delete all CID records Withheld CallMessage Waiting LNR Function Last Number Redial Redial the last numberStore the last number dialled Delete last number dialledPhonebook Add new recordsReview / Edit / Dial stored Phonebook records With base unit Delete one record Delete all records with base unitMenu Setup Audio settingsAudio TAD setting Pabx setting Setting Ring Loudness Key Tone Dashes toAnswering system TAD settings Ringer melody settingRinger loudness setting Key tone settingAnswering mode setting TAD rings settingTAD PIN setting Call screen mode settingPabx settings Preﬁx number settingPreﬁx setting Preﬁx Number Dashes to showGeneral settings Contrast settingLanguage setting Date / Time settingHandset ringer adjustment Handset ringer volumeCordless Handset Operation Handset ringer melodyMulti-handset Operation Intercom functionCall transfer between cordless handsets Register new handsets on the M5500 base Cordless handset keypad lockRegistration Language setting Remove handsetsReset Handset nameOGM setting Answering Machine OperationAnswering machine On / Off OGM Outgoing MessagesRecord OGM Play OGMDelete OGM OGM play to linePlay ICM ICM Incoming MessagesRecord ICM Memo Delete messagesRecord memo Play memoDelete all messages Memory fullPage Setting section on P30 Call screeningToll saver Remote turn-onTroubleshooting AppendixProduct Speciﬁcations Phone Oricom M5500 SpeciﬁcationsREN RN for New Zealand Caller IDExclusion and limitation of liability Warranty InformationWarranty Customer Support