Getting Started and Using Masks
To align a Mask to the waveform
To align a Mask to the waveform
1Access the Mask Test Setup dialog box and make sure the mask test is enabled.
2Locate the Use File Setup When Aligning option.
When aligning a mask to the waveform, these settings are used:
•Channel range and offset
•Time base range and position
•Trigger mode and level
•Mask test scaling source, position(s), and delay
You can either use the current oscilloscope settings, or you can use the standard settings defined in the mask file.
3If you want to use the standard settings defined in the mask file, checkmark the Use File Setup When Aligning option.
4If you want to use the current oscilloscope settings, do not checkmark this box.
When aligning a mask, you can use the current settings for the oscilloscope setup, or use the standard settings in the mask file.
5Click the Align button to align the mask.