Talkswitch E3 manual Connecting Phones TWO Line Phone Option, Extensions 111

Page 5

C O N N E C T I N G P H O N E S , F A X E S A N D D E V I C E S T O T A L K S W I T C H

Incoming

Phone Lines TalkSwitch Jacks E1 E2 E3 E4

CONNECTING PHONES: TWO LINE PHONE - OPTION 1

Call Handling:

TalkSwitch extensions 111 and 112 are wired to a two line phone. When a call is transferred to extension 111, line 1 on the phone will show as active; simi- larly calls on extension 112 will show line 2 as active.

Through the software, you may configure each incoming line to ring any given number of extensions, including all extensions. However, be careful if incoming line 1 is con- figured to ring both extensions 111 and 112. An incoming call will ring both phone lines at the same time. Instead configure incoming line 1 to ring extension 111, and

line 2 to ring extensions 112.

Extensions 111 and 112

Two line phones must have these two phone jacks labeled “L1/L2” and “L2”. The jack labeled “L1/L2” will have 4 pin connectors and the “L2” jack will have 2 pin connectors.

L1OORLL1/L2/L

To Tel. Line L1 or L1/L2

To Tel. Line L2

L2

Ext 111

To Jack E1

Each phone is connected to a single line RJ-11 cable. The jacks at the end of the cables should have two pins as shown below..

Single Line RJ-11 Jack

Ext 112

Pin 1

 

To Jack E2

Pin 2

 

W W W.T A L K S W I T C H . C O M

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents What will MY Phone System DO? Suggested ConfigurationIncoming Phone Lines Connecting DevicesLocal Extensions LocationCall Handling Wiring PhonesPin Ext Connecting Phones Single Line PhoneTo Tel. Line Extensions 111 Connecting Phones TWO Line Phone OptionPhone Lines IncomingLine Splitter Extensions 111 To Tel. Line L1 or L1/L2 Line Splitter ExtConnector Line Splitter Connecting Phones MULTI-LINE PhonesTo Tel. Line L1/L2 To Tel. Line L3/L4 Male 4 pin ExtChoose a Method to Handle Incoming Faxes Connecting FaxesOption 1 Dedicated Fax Line Option 2 Distinctive RingWhich Option Do You Prefer? Dedicated FAX LineOption 3 Automatic Detection via the Auto Attendant Set Fax Detection on Distinctive Ring Number Distinctive Ring FAX DetectionSet Distinctive Ring Numbers Reconnect Phones and other Devices to TalkSwitch Save Settings to TalkSwitchConnect Fax to TalkSwitch Automatic Detection via the Auto Attendant Configure the Auto AttendantStep a Step B Step C Configure Incoming Phone LinesRecord Auto Attendant Prompts ? What Should an Auto Attendant Say?
Top Page Image Contents