Siemens Gigaset 2010 Procedure in the case of malfunctions, Symptom Cause Remedy

18.11.98 Kap03.fm5 Gigaset 2010, UEB/engl.: A30852-X1100-E301-3-7619

Notes on operation

Procedure in the case of malfunctions

Not every malfunction means that there is an actual de- fect in your telephone. In some situations you may save time and money if you can eliminate the cause of simple faults yourself. The information below will help you do this.

Symptom	Cause	Remedy
No display appears	Handset is not switched on.	Switch on the handset.
	Battery is empty.	Replace the battery with a backup
		battery or recharge it.
Cannot seize the dial-up line;	The plug on the power cord	Check the plug on the base station
no dial tone	is not connected properly.	and telephone socket; if necessary
		remove it and plug it back in
		(➔ page 2).
	The plug on the power cord	Check the plug on the base station
	is not connected properly.	and the socket; if necessary
		remove it and plug it back in
		(➔ page 2).
	The dial-up line is being used	Wait until the dial-up line is free.
	by another handset.
Cannot set up a radio link to	Handset is not registered.	Register the handset at the base
the base station – symbol on		station (➔ page 49).
the handset flashes.
	The plug on the AC power	Check the plug on the base station
	adapter cord is not connec-	and the socket; if necessary re-
	ted properly.	move it and plug it back in.
Base station or handset does	Ringer volume is set to low.	Adjust the base station
not ring.		(➔ page 32) or handset
		(➔ page 34) ringer volume.
	The ring assignment is not	Adjust the ring assignment
	set correctly.	(➔ page 51).
No connection after dialing a	Wrong signaling method.	Reset the signaling method
call number; dial tone can		(➔ page 16).
still be heard.
No connection after a con-	Wrong signaling method.	Switch the signaling method
nection has been set up; dial		(➔ page 18).
tone can still be heard.

11