BT 200 manual Plug the mains adaptor into the wall socket and switch on

Page 10

Paragon 200 - Edition 4.3 – 26th Sept ’00

6Plug the mains adaptor into the wall socket and switch on

The Paragon 200 automatically goes through a start-up process during which the display shows init, and both the secrecy LED and message indicator flash once.

On completion the unit will beep and the display will show the number of messages.

Your Paragon 200 is now ready to record messages.

Please Note

Your machine automatically adds the time and

day to each incoming message recorded.

7Fit plinth for desk mounting and track cables

If you use your Paragon 200 as a desk phone you will need to fit the stand on to the base.

Ensure all the cables on the underside of the base are in their respective channels.

Proceed by holding the stand as shown in the illustration, ensuring the two arrows are facing each other.

Now lower the stand so that the two lugs nearest to you, fit into the corresponding holes on base, as shown.

Push and squeeze until the stand clicks into place from front and back as shown in the inset.

ARROWS

SETTING UP

7

Image 10

Contents UserGuide ParagonParagon 200 Edition 4.3 26th Sept ’00 Paragon 200 Edition 4.3 26th Sept ’00 At a glance Allows you to change the display contrastDefault TB Using the telephone This guide For your records Introduction Unpacking your Paragon Enter your PIN herePlan the location of your Paragon Setting upInsert back-up battery It should not be used in bathrooms or near waterConnect the telephone line cord Check Dial Mode setting default TBConnect handset cord to base Plug the mains adaptor cord into the back of the telephonePlug the mains adaptor into the wall socket and switch on Fit plinth for desk mounting and track cablesTo set the day and time Says Please enter the time using the 24 hour clockWall-mounting your Paragon Press buttons in the order shownUsing the Inductive Coupler Using the telephoneMaking and ending calls To store a one-touch number Using the one-touch buttonsTo adjust the earpiece volume during a call To make a one-touch callTo make a quickdial call To store a quickdial number Using the quickdial memoryTo delete/change a quickdial number Using the answering machine To switch the answering machine on, off and to Answer OnlyTo record a memo To record your own outgoing messageTo delete your personal OGM To privately playback your messages through the handset Message and Ring IndicatorTo playback your messages To delete all messagesTo switch on Caller Return To use Call Screening Using Remote AccessTo adjust the playback volume To use Caller Return AutoUse the keypad to enter your security To switch on your answering machineTo set your PIN To play back messages PIN. Wait to hear the confirmationTo adjust the ring tone Optional SettingsRinger To adjust the display contrast To adjust the ringer volumePrompt says Please select the ringer Guarantee SafetyGeneral information Technical information Help and advice0845 330 If the power fails Wall-mounting template Index Rtte Offices worldwide

Related manuals

Manual 6 pages 4.13 Kb