Memorex MPH7895 manual Battery Safety Instructions, Installation Precautions

Page 5

SAVE THESE INSTRUCTIONS

BATTERY SAFETY INSTRUCTIONS

CAUTION:

To reduce the risk of fire or injury to persons, read and follow these instructions:

1.Use only the following type and size of handset battery pack: Cordless Telephone Battery Pack

DC3.6V, 800mAh, Ni-Cd Battery Pack

2.Do not dispose of the battery in a fire. The cell may explode. Check with local codes for possible special disposal instructions.

3.Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.

4.Exercise care in handling the battery in order not to short the battery with conducting material such as rings, bracelets and keys. The battery or conductor may overheat and cause burns.

5.Recharge only the battery provided with or identified for use with this product. The battery may leak corrosive electrolyte or explode if it is not the correct type.

6.Do not attempt to rejuvenate the battery provided with or identified for use with this product by heating them. Sudden release of the battery electrolyte may occur causing burns or irritation to eyes or skin.

7.When inserting the batteries into this product, the proper polarity or direction must be observed. Reverse insertion of batteries can cause charging that may result in leakage or explosion.

8.Remove the batteries from this product if the product will not be used for a long period of time (several months or more) since during this time the battery could leak in the product.

9.Discard "dead" batteries as soon as possible since "dead" batteries are more likely to leak in a product.

10.Do not store this product, or the battery provided with or identified for use with this product, in high-temperature areas. Batteries that are stored in a freezer or refrigerator for the purpose of extending shelf life should be stabilized at room temperature prior to use after cold storage.

11.Disconnect telephone lines before installing batteries.

INSTALLATION PRECAUTIONS

1.Never install telephone wiring during a lightning storm.

2.Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

3.Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.

4.Use caution when installing or modifying telephone lines.

4

 

Page 5

7/5/01, 4:07 PM

 

 

 

MPH7895/04281A(English).put

Adobe PageMaker 6.5C/PPC

 

 

 

 

 

 

 

Page 4 Page 6
Image 5
Page 4 Page 6
Contents MPH7895 Important Service Information Carton Contents Important Safety Instructions Installation Precautions Battery Safety InstructionsFCC Notice Table of Contents Handset Controls Cordless Telephone DescriptionControls Location and Function Handset Controls Answering System Base Unit Controls Code Function Mounting PositionDesktop USE Wall USEBase Unit Power Connection Connecting the HeadsetBelt Clip Instruction Wall Mounting No Standard Wall JackSetting the DAY and Time of the Base Unit Handset Battery InstallationInitial Setup If the Handset is on the Base Unit Telephone OperationIf the Handset is OUT of the Base Unit When the Handset is OFF the Base Unit and in Standby ModeStoring Telephone Numbers Into Memory Dialing Directory Storing Telephone Numbers Into the Speed Dialing ListDeleting Single Memory Location Deleting Stored Telephone NumbersDeleting ALL Memory Location Dialing from the Memory Dialing DirectoryManual Channel Scan Auto Channel ScanAnswering Machine Operation To Turn Answer Mode OFFTo Turn Answer Mode on Skipping Messages Playing MessagesPrevious Messages Stop Message PlaybackErasing ALL Memo Messages Erasing ALL ICM and TWO-WAY RecordingsErasing OGM From the Extension PhoneRemote Operation Using the HandsetCalling the Unit from a Tone Phone Voice Help MenuSetting the DAY and Time Changing the PasswordSetting Answer Mode to on Setting Answer Mode to OFFIntroduction to Caller ID and Call Waiting ID Caller ID OperationQuestions Answers Receiving NEW CallCallback Option Deleting Single Call RecordDeleting ALL Call Records HOW to Change the Language Summary of Function ModeHOW to SET Cidcw on / OFF HOW to SET User and Neighboring Area CodeHOW to Adjust the Contrast of LCD Display HOW to SET Ringer on / OFFHOW to SET Time Deleted Empty Data Error LCD Display Symbols and MessageLong Distance No Calls John SmithImproving Cordless Reception Maximizing Battery LifeMaintenance Symptoms Possible Solution / Cause TroubleshootingPhone answering device TAD connected with the unit Technical Information Adapter Use only with Class 2 Power Source 9VAC 500 mADistributed Exclusively by Memorex MPH7895 / 04281A-1
Top Page Image Contents