Advanced Features
32
Scan
When you start a scan, your radio cycles through the programmed scan list for the current channel looking for voice activity.
The yellow LED blinks and the scan icon appears on the status bar.
During a dual mode scan, if you are on a digital channel, and your radio locks onto an analog channel, it automatically switches from digital mode to analog mode for the duration of the call. This is also true for the reverse.
There are two ways of initiating scan:
•Main Channel Scan (Manual): Your radio scans all the channels/groups in your scan list. On entering scan, your radio may – depending on the settings – automatically start on the last scanned “active” channel/group or on the channel where scan was initiated.
•Auto Scan (Automatic): Your radio automatically starts scanning when you select a channel/group that has Auto Scan enabled.
NOTE: This feature is not applicable in Capacity Plus and Linked Capacity Plus.
Starting and Stopping Scan
Procedure:
Press the programmed Scan button to start or stop Scan. OR Follow the procedure below.
1Use the Scroll Up/Down buttons to select a channel programmed with a scan list.
2g to access the menu.
3f or h to Scan and press g to select.
4f or h to Scan State and press g to select.
5f or h to required scan state and press g to select.
6The display shows Scan On when scan is enabled. The yellow LED blinks and the scan icon appears.
OR
The display shows Scan Off if scan is disabled. The LED turns off and the scan icon disappears.
While scanning, the radio can only accept data (e.g. text message, location, telemetry, or PC data) if received on its Selected Channel.
English