VTech i6790, i6789 Remote access, Commands in remote standby mode, Commands during playback mode

Page 36

•If no key is pressed after entering remote access, any new messages will be played automatically.

•Once the new messages have been played, the system will announce the help menu options. If no key is pressed within 20 seconds, the remote access call is automatically disconnected.

•If you access the answering system remotely when the memory is full, the system will announce “Memory is full, enter your remote access code from any touch tone telephone.”

33

Answering system operation

Remote access

You can access many features of your answering system remotely from any touch tone telephone. A two-digit security code is required to access the system and the factory default code is 19; see page 29 to change it. To access remote access:

•Dial your telephone number from any touch tone telephone.

•When the system answers and announces the greeting, enter the two-digit security code.

•After hearing a double beep, enter one of the remote commands in the following table.

•Hang up or press 8 to end the call.

Commands in remote standby mode:

Hang up	Saves all messages
1	Plays all messages
2	Plays new messages only
3 (twice)	Deletes all old messages while no message is currently playing
4	Repeats the currently playing message
*5	Plays help menu
5	Stops
*7	Records the outgoing announcement
8	Disconnects the call
0	Turns answering system on or off
Commands during playback mode:
3	Deletes the message currently playing and announces "Message deleted."
4 (twice)	Plays the previous message

6Skips to the next message www.vtechphones.com

Image 36

Contents Need HELP? Table of contents Battery Important safety instructionsTroubleshooting MaintenanceInstallation Parts checklistInstallation Telephone base installationInstall handset battery Belt clip & headset optional HeadsetBelt clip Voicemail service About caller IDIf you subscribe to DSL service Wall mounting bracket installation optional Desk/table bracket installationTelephone settings Handset layoutFlash SpeakerTelephone base layout Ringer volume Ringer melodySettings menu Key toneLanguage Clock setting Dial typeClear voicemail Display menu WallpaperContrast Basic operation Make, answer, and end calls with the handsetHandset speakerphone MuteVolume IntercomRinger mute Call waitingConference call Transfer an external callFLASH, or Answering intercom and external calls Answer an incoming call during an intercom callFind handset Advanced operation DirectoryStore a directory entry Chart of characters Number Characters by number of key presses Key SpaceSearch the directory Dial a directory entryEdit a directory entry Delete a directory entry Call log Review the call logMake CID entries ready to dial Dial a call log entrySave an entry to the directory Delete one or all entries Handset display screen messagesDisplay Means Redial list Dial from redialDelete a redial entry Answering system operation Message capacityAnswering system setup Activate the answering systemSet the clock Set number of rings Set base ringerSet remote access code Set message alert toneOutgoing announcement Record your announcementPlay your announcement Message playback Delete your announcementNew message indication Options during playbackRecord and play memos Record a memoMemo playback Remote access Commands in remote standby modeCommands during playback mode Message window Handset display screen messages Appendix Handset and base indicators Handset indicator lightsBattery indicator Base lightsBattery Important safety instructions Troubleshooting Problem SuggestionBase or charger should be on For this to take place Before dialing Troubleshooting My caller ID features are CONNECTING... is DialAnswering system To one minute for this to take place Maintenance Operating rangeWarranty About cordless telephonesHow do you get warranty service? FCC, Acta and IC regulations FCC PartRbrc Seal Industry CanadaTechnical specifications Index Index 91-001070-060-100 User’s manual