VTech i6789, i6790 important safety instructions Installation, Telephone base installation

Page 5

Installation

Telephone base installation

It is recommended to install the telephone base away from any electronic equipment and appliances such as personal computers, computer routers, television sets, microwave ovens, and refrigerators. Avoid excessive heat, cold, dust or moisture. When a location is selected, install the telephone base and the charger as shown below.

Plug the connector into the power jack at the bottom of the telephone base and chargers. Route cords through slots and plug the power adapter into an electrical outlet not controlled by a wall switch.

Plug one end of the telephone line cord into the telephone line jack at the bottom of the telephone base. Route the telephone line cord through slot, then plug the other end of the cord into the modular wall telephone outlet.

Your telephone base comes with the bracket installed for desktop use. If you prefer to mount your telephone on the wall, plug in the telephone line cord and the power adapter to the telephone base as instructed above before changing it to a wall mount position (see page 7 for bracket installation).

Use only the AC

power adapter

supplied with this

telephone.

• This power unit

is intended to be

correctly oriented

in a vertical

or floor mount

position. The

prongs are not

designed to hold

the plug in place

if it is plugged

Installation

Basic operation

Plug the telephone line cord into a telephone jack.

Plug power adapter into an electrical outlet not controlled by a wall switch.

into a ceiling or

an under-the-

table/cabinet

outlet.

www.vtechphones.com

Image 5
Contents Need HELP? Table of contents Important safety instructions BatteryTroubleshooting MaintenanceParts checklist InstallationTelephone base installation InstallationInstall handset battery Belt clip Belt clip & headset optionalHeadset About caller ID Voicemail serviceIf you subscribe to DSL service Desk/table bracket installation Wall mounting bracket installation optionalHandset layout Telephone settingsFlash SpeakerTelephone base layout Ringer melody Ringer volumeLanguage Settings menuKey tone Clear voicemail Clock settingDial type Contrast Display menuWallpaper Make, answer, and end calls with the handset Basic operationHandset speakerphone MuteIntercom VolumeRinger mute Call waitingFLASH, or Conference callTransfer an external call Find handset Answering intercom and external callsAnswer an incoming call during an intercom call Store a directory entry Advanced operationDirectory Number Characters by number of key presses Key Space Chart of charactersEdit a directory entry Search the directoryDial a directory entry Delete a directory entry Review the call log Call logSave an entry to the directory Make CID entries ready to dialDial a call log entry Display Means Delete one or all entriesHandset display screen messages Delete a redial entry Redial listDial from redial Message capacity Answering system operationSet the clock Answering system setupActivate the answering system Set base ringer Set number of ringsSet message alert tone Set remote access codePlay your announcement Outgoing announcementRecord your announcement Delete your announcement Message playbackNew message indication Options during playbackMemo playback Record and play memosRecord a memo Commands during playback mode Remote accessCommands in remote standby mode Message window Handset display screen messages Appendix Handset indicator lights Handset and base indicatorsBattery indicator Base lightsBattery Important safety instructions Problem Suggestion TroubleshootingBase or charger should be on For this to take place Before dialing Troubleshooting My caller ID features are Dial CONNECTING... isAnswering system To one minute for this to take place Operating range MaintenanceAbout cordless telephones WarrantyHow do you get warranty service? FCC Part FCC, Acta and IC regulationsIndustry Canada Rbrc SealTechnical specifications Index Index 91-001070-060-100 User’s manual