Answering system operation
Customize the announcement only message
1.Press SETUP four times, the system announces “Announcement only. Record no messages. To change the setting, press CHANGE”.
2.Press CHANGE until you hear the desired option.
3.Press SETUP three times, the system announces “Announcement. Press PLAY or press RECORD. To continue, press SETUP”.
4.Press REC/MEMO 
. The system announces, “Record after the tone. Press STOP when you are done”. Speak toward the MIC on the base to record an announcement for up to 90 seconds.
5.The elapsed time (in seconds) will be shown in the message window as you record.
6.Press PLAY/STOP 
/ 
when you’ve finished recording. The system will play back your recorded message then save it.
Base ringer
1.Press SETUP five times, the system announces “Base ringer. To change the setting, press CHANGE”.
2.Press CHANGE.
3.Press CHANGE again until the desired base ringer sounds.
4.Press SETUP to save your selection and advance to the next setup option, or press PLAY/STOP 
/ 
to save and exit.
Toll saver
This function sets the number of rings before the answering system picks up the call. With the toll saver setting activated, the answering system alerts you whether there are new messages when calling remotely from a touch tone phone. If there are new messages on the answering system, the system picks up the call after two rings. When retrieving messages from a location where long distance charges apply, you may disconnect your call after three rings to avoid long distance charges.
Basic operation
www.vtechphones.com | 37 |