61200375L1-1 TA 850 T1 RCU VoATM UIG/61200376L2-31A
Page 21 of 72
Refer to the next section, Configuring the TA 850, for general configuration instructions.
Refer to the appendices at the end of this document for information on using the TA 850 in specific applications:
• Appendix D. Voice Gateway Quick Start Procedure (Voice Turn up) on page 65.
•Appendix E. RFC1483 Quick Start (IP Routing) on page 67.
•Appendix F. RFC1483 Quick Start (IP Routing with NAT) on page 69.
•Appendix G. RFC1483 Quick Start (Bridging) on page 71.
4.INSTALLING A MODULE
After installing the TA 850 Base Unit and connecting the required cables, you can install necessary modules.
Remove the 20 Hz fuse before exposing backplane or accessing channel units.
Electronic modules can be damaged by static electrical discharge. Before handling modules, wear an antistatic discharge wrist strap to prevent damage to electronic components. Place modules in antistatic packing material when transporting or storing. When working on modules, always place them on an approved antistatic mat that is electrically grounded.
Individual access modules insert from the front. A locking bar holds the modules in place for added security. Disen- gaging the captured screw allows removal of the locking bar. All wiring connections terminate on the backplane.
The following step/action table tells how to install a module.
Instructions for Installing Module in the TA 850
Step | Action |
1Hold the module by the faceplate while supporting the bottom side.
2Align the module edges to the guide grooves for the designated slot.
3Insert the module until the edge connector seats firmly into the backplane.
4Lock the unit in place by pushing in on the locking lever.
5Connect the cables to the associated device(s).
© 2001, ADTRAN, Inc. | TA 850 User Manual |