61200375L1-1 TA 850
T1 RCU VoATM UIG/61200376L2-31A Page 58 of 72
Perform Steps Below in the Order Listed
1.Using a Telnet program, log in to TA 850.
2.Select SYSTEM UTILITY / UPDATE FIRMWARE.
3.Select TFTP for TRANSFER METHOD.
4.Enter into TFTP SERVER IP ADDRESS, the IP address of the network server that was recorded earlier.
5.Enter into TFTP SERVER FILENAME, the full path name and filename of the update file that was recorded earlier.
6.Select START TRANSFER <+> to start the update process. Enter Y to confirm the transfer and to set up the module to receive the TFTP upload.
During the TFTP upload process, various status messages display in CURRENT UPDATE STATUS to indicate progress. The table below describes these messages.
When the update has successfully completed, TRANSFER COMPLETE displays in TRANSFER STATUS. The TA 850 restarts immediately and resumes operation.
If an error occurs during the update, an error message will display in the TRANSFER STATUS field. If this occurs, return to Step 3 and attempt the update again. If the same error occurs, contact ADTRAN Technical Support.
During the TFTP upload, various status messages display to indicate progress. The following table describes these messages.
Message | Meaning |
|
|
|
|
Contacting Server | Indicates communication with the TFTP network server |
| is trying to be established with the specified server |
| address in the TFTP Server IP Address field. |
|
|
Beginning TFTP | Indicates communication with the TFTP network server |
Transfer | has been established and the update file is being trans- |
| ferred between TA 850 and the TFTP network server. |
|
|
Completed | Indicates the TA 850 product successfully received the |
| update file. |
|
|
TA 850 User Manual | © 2001, ADTRAN, Inc. |