Spectrum Brands SP-550 manual Connecting the Handset Cord, Installing the Keycaps

Connecting the Handset Cord

A 10 foot modular coil handset cord is provided. (Be sure that the wall/desk eleva- tion stand has not been attached). To install the cord, simply plug the short end of the handset cord into the modular jack on the handset. The long end of the handset cord plugs into the jack labeled “Handset” located on the bottom of the SpectrumPLUSTM base unit. Place the line cord into the line cord channel located directly below the jack.

Installing the Keycaps

Twenty-two preprinted named feature keycaps are provided to identify the speed dial key.

There are 11 clear keycaps already installed. To install pre-printed keys, remove the clear keycap by simply pulling up. Replace with the preprinted keycaps or place hand written paper index sheets under a clear keycap. Program each speed dial key for the specific function of the key.

CLEAR "SNAP-ON" KEY CAP OR SILK SCREEN KEY CAP

PLASTIC TOP CABINET

PLASTIC TOP CABINET

PLASTIC KEYTOP

For speed dial programming instructions, see the section on “Programming Procedure For SpectrumPlustm Speed Dial Features” in this manual.

There are 4 additional clear keycaps and 2 index sheets provided as spares. Use these for your own personal speed dial identities. Write the speed dial name on the blank speed dial index cards and insert into the blank keycaps. Place the keycap on the correct memory speed dial location. (see index sheets provided in box).

The twenty-two preprinted keycaps are described below:

Call Fwd On	Call Back	Paging	Skip Msg	Information
Call Fwd Off	Cancel Call Back	Ring Again	FF Msg	911
Transfer	Call Park	Save Msg	Rew Msg
Conf	Call Pick-up	Del Msg	Emergency
DND	Group Call Pic k-up	Rpt Msg	Help Desk

18