Spectrum Brands SP-550 manual Administrator Programmable Only Manual Entry of Characters

Programming Procedure for SpectrumPlus tm Speed Dial Features

(Administrator Programmable Only) (Manual Entry of Characters)

The SpectrumPLUSTM Telephone has 11 one-touch speed dial locations that are convenient for dialing frequently used telephone numbers. This feature is under Administrative control so user changes do not occur.

?Speed dial programming must be done with the telephone plugged into the telephone line and power adapter.

?Programming can be performed with the telephone on-hook only.

?A maximum of 32 digits can be entered into ENTER NUMBER and 12 characters into ENTER NAME.

ENTER NUMBER	Set up speed dial memory
	locations with name and		12/01	PM
	number entries. Check
ENTER NAME	verifies correct entry.
		ENTER ACCESS NO.
To Program Speed Dial Locations					Figure 1

1.Press and hold the “STORE” key for 6 seconds to activate Administrator mode. The words “ENTER

ACCESS NO.” will appear (figure 1). 12/01 PM

2.Next, press the speed dial location key where the desired location will be. The display will read

	“Mxx NO CONTENT”. If the display shows a		M01 NO CONTENT
	record, then there is a stored name and number in
	that location (figure 2).				Figure 2
3.	Press the “STORE” key again and the display will
	read “ENTER NUMBER” (figure 3).
4.	Using the dial pad, enter the number. Note that the
	local area code is not required if AREA CODE is			12/01 PM
	pre-programmed into memory.
5.	After entering the number, press the	“STORE”
	key. The display will read	“ENTER	ENTER NUMBER
	NAME” (figure 4).
6.	Using the keypad, enter the name associated with				Figure 3
	the number being programmed and include the
	Flash, and/or Pause, when needed.

7.Press the “STORE” key to store the entry.

8.Program other speed dial locations, repeat 2 to 7.

9. To exit the program mode, press “DISC”. 12/01 PM

ENTER NAME

34

Figure 4