Wall Mounting the SpectrumPLUSTM Telephone
The SpectrumPLUSTM was designed to be conveniently
Retaining Clip
1. 
PULL OUTWARD
wall mounted without requiring additional hardware.
2. ROTATE 180 .
CLIP IS SPRING LOADED
!
Follow these easy steps:
1.The handset retaining clip must be in the correct position to secure the handset into the handset cradle. To engage the clip, pull the clip forward (outward) with your fingers, rotate the clip 180º and snap the clip back into place (figure 1). The retaining clip cannot be removed because it is spring loaded.
2.The SpectrumPLUSTM has provisions for a mounting wedge that must be correctly positioned. This wedge allows the telephone to be viewed at a correct angle when the phone is wall mounted. Remove the wedge from the phone base (figure 2).
3.Secure the wiring in place prior to installing the wall mount wedge. The wall mount base has extra large wiring channels and strain relief poles for containing the wires in a neat and orderly way. Wrap the wires around the strain relief poles and then secure the wires through the channel.
4.To wall mount, place the narrow edge at the top edge of the phone base and slide the wedge upward into place (figure 3).
5.Lock the wall mount into position by sliding the locking button to the right (figure 4).
Note: A 6 inch line cord is provided for wall mount installation. Connect one end of the line cord to the phone jack and the other end to the wall jack.
Desk Mounting
3.
SNAP INTO PLACE.
figure 1
Remove Mounting Wedge
Spectrum Plus Bottom | Mounting Wedge | figure 2 |
Replace Mounting Wedge
| Mounting Wedge | figure3 |
Spectrum Plus Bottom |
|
Lock Mounting Wedge
Mounting Wedge
Lock mounting wedge |
Spectrum Plus Bottom
figure 4
To install the wedge for desk mounting, be sure the lock mechanism is positioned to the left clear of the locking arm. Place the wedge in the slots, wide end toward top of phone base unit, and slide the wedge upward into position. Lock the wedge into place.
19