AT&T TL92378 user manual Telephone base installation

Getting started

Telephone base installation

Install the telephone base as shown below. Make sure that the electrical outlet is not controlled by a wall switch.

If you subscribe to high-speed Internet service (digital subscriber line - DSL) through your telephone line(s), you must install a DSL filter between the telephone base and the telephone wall jack. The filter prevents noise and caller ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters.

The telephone base is set for desktop use. If you want to change to wall mounting position, you will need to install the supplied wall mount bracket to the telephone base, see page 10- for details.

2.Route the power cord through the slot next to the telephone jack.

1.Plug the small end of the power adapter into the power jack at the bottom of the telephone base.

6.Plug the large end of the power adapter into a power outlet not controlled by a wall switch.

Power adapter

3. Plug one end of

	the telephone
	line cord into the
	telephone jack at
	the bottom of the
	telephone base.
4.	Place the cords
	into the bracket
	channels.
Telephone	5. Plug the other
line cord	end of the
	telephone
	line cord into
	a telephone
	jack.

DSL filter (not included), required if you have DSL high-speed Internet service.

7.Raise the antenna.