AT&T TL92378 Answering system mode, Call screening at the telephone base, Call intercept

Answering system

Answering system mode

Unless you change it, the answering system will be on and ready to record messages. You can turn the answering system off, but if you do so, the answering system will not answer calls and record incoming messages.

To turn the answering system on or off:

• Press ANSWER ON to turn off your answering system. The system will announce “Calls will not be answered” and then beep to confirm the system is off. The ANSWER ON light will be off.

•To turn the system back on, press ANSWER ON. The system will announce “Calls will be answered” and then beep to confirm the system is on. The ANSWER ON light will be on.

NOTE: If the answering system is off and there is an incoming call, the system will answer after 10 rings and announce to the caller, “Please enter your remote access code.” For more information about remote access codes, see pages 66-67.

Call screening at the telephone base

If the answering system is on and the telephone base volume is not off (set to 2 or higher), you will hear the announcement and the incoming message when a call comes in. If you want the telephone base to be silent while messages are being recorded, make sure the telephone base volume is set to 1.

Call intercept

While screening a call, you can stop recording and speak to the caller by pressing

HOME/FLASH or SPEAKER on the handset.

55