AT&T TL92378 user manual Day not set

Appendix D

Troubleshooting

•If you subscribe to high-speed Internet service (digital subscriber line - DSL) through your telephone lines, you must install a DSL filter between the telephone base and the telephone wall jack (page 6). The filter prevents noise and caller ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters.

System does	•	Make sure you subscribe to caller ID with call waiting
not receive		features provided by your local telephone company.
caller ID when		Caller ID features will work only if both you and the
on a call.		caller are in areas offering caller ID service, and if both
		telephone companies use compatible equipment.
Incomplete	•	If a caller leaves a very long message, part of it may be
messages.		lost when the system disconnects the call after
		four minutes.
	•	If the caller pauses for longer than seven seconds, the
		system stops recording and disconnects the call.
	•	If the system’s memory becomes full during a message,
		the system stops recording and disconnects the call.
	•	If the caller's voice is very soft, the system may stop
		recording and disconnects the call.
Difficulty hearing	•	Press VOLUME to increase speaker volume.
messages.

System does not answer after correct number of rings.

•Make sure that the answering system is on (page 55).

•If toll saver is activated, the number of rings changes to two when you have new messages stored (page 59).

•If the memory is full or the system is off, the system will answer after 10 rings.

System	• You need to reset the answering system clock (see
announces “Time	pages 53-54).
and day not set.”

83