AT&T 9353 user manual Headset Jack, Operating Range

Page 12

9353_book_1ATT 6/7/01 1:56 PM Page 8

TELEPHONE OPERATION

Headset Jack

You can use this telephone hands-free when you install any AT&T 2.5 mm headset, purchased separately.

Plug the headset into the jack under the small rubber flap. Do not force the connection, but make sure the plug fits securely

Operating Range

This cordless telephone operates within the maximum power allowed by the Federal Communications Commission (FCC). Even so, this handset and base can communicate over only a certain distance — which can vary with the locations of the base and handset, the weather, and the construction of your home or office. For best performance, keep the base antenna fully upright.

If you receive a call while you are out of range, the handset might not ring — or if it does ring, the call might not connect when you press P. Move closer to the base, then press Pto answer the call.

If you move out of range during a phone conversation, you might hear noise or interference. To improve reception, move closer to the base.

If you move out of range without pressing O, your phone will be left “off the hook.” To hang up properly, walk back into range, periodically pressing O.

8

Image 12

Contents Revised Part 1 Important Product InformationAdvanced American Telephones. All rights reserved Contents 9353book1ATT 6/7/01 156 PM Installation Before You InstallInstall the handset battery Attach the belt clip to the cordless handset optional Charge the handset battery Set the dial modeCheck for dial tone Wall Installation Connect the telephone line cord Connect the power cordFollow Steps 3-5 in Table/Desk Installation Mount the base on the wallTelephone Operation Page/Handset Locator Temporary Tone Dialing Handset Ringer StyleRinger Off Headset Jack Operating RangeTelephone Memory Audible Indicators Answering System OperationSet the Clock About MailboxesRecord Your Announcement Press Uuntil you hear Change announcementAnswering System Feature Setup Feature SummaryVolume Listen To, Save & Delete MessagesCall Screening/Intercept Record a MemoMessage Window Display Remote Access Commands Connect with the Answering SystemVoice Menu End remote access call Record memoTurn system off Turn system onCharging the Handset Battery Pack Replacing the Handset Battery PackBatteries If the phone does not ring when you receive a call Case of DifficultyIf the phone doesn’t work at all, check these items first If you hear noise or interference when using the phone If you hear other calls while using your phoneIf you lose a call after changing channels If messages are incompleteIf you have difficulty hearing messages If CL appears in the Message WindowIf your outgoing announcement isn’t clear