9353_book_1ATT 6/7/01 1:56 PM Page 17
BATTERIES
Charging the Handset Battery Pack
This battery should remain charged up to six days with the ringer turned on and up to 12 days with the ringer off. A fully charged battery provides an average talk time of about six hours.
The battery pack needs charging when:
•A new battery is installed in the handset.
•The phone beeps twice when you press P.
•The phone light flashes slowly.
Place the handset in the base so the CHARGING light turns on. The battery pack is typically fully charged in eight hours.
You can keep the battery fully charged by returning the handset to the base after each use.
If you repeatedly get a low battery indicator, even after eight hours of charging, the battery should be replaced. Use only AT&T battery 3301 (SKU# 91076).
CAUTION: Charge the battery provided with or identified for use with this product only in accordance with the instructions and limitations specified in the User’s Manual, Part 1.
Replacing the Handset Battery Pack
1Remove the battery compartment cover on the handset by press- ing on the indentation and sliding the cover downward.
2Lift out the old battery pack and disconnect.
3Plug battery pack connector into handset. Place the battery pack and wires in the compartment.
4Replace the cover by sliding it up into place.
5The new battery pack must be charged before using the phone. Place the handset in the base and allow it to charge for at least 24 hours the first charge. The telephone might operate before that, but for best performance, let the battery pack charge fully.
17