6
Connecting the FastRAD
When equipment and environment conditions have been veri- fied, you can begin connecting the FastRAD to the distribution block.
Before you connect the FastRAD, make sure the port works. Attach a working Norstar
To connect the FastRAD:
1.Plug the barrel connector of the power supply into the power connector of the FastRAD and the other end into the wall outlet. See Figure 2.
This unit must be powered from a pluggable
Type A Class 2 power source that is UL and
CSA listed.
2.Check that the LED on the FastRAD unit is lit to confirm the power connection.
3.Locate the distribution block.
4.Mount the
5.Using twisted pair station wire, connect the teladapt jack to a free station port at the distribution block.
Note: Do not connect the FastRAD to port 101. This port is reserved for the prime set. The FastRAD should be con- nected to one of the