13
General Programming
General programming allows you to define the System ID number.
Before you begin entering general programming information, make sure the display shows RAD Admin. If you do not have this display on the Norstar telephone, follow the steps in Starting a Programming Session.
To enter general FastRAD programming information:
1.Press GEN.
The display shows: | System ID number | |
| BACK | SHOW NEXT |
2.Press SHOW.
The display shows: -
BACK CHNG NEXT
Note: If this is a first time installation, we recommend the system ID number must be programmed to allow remote access. If this is not a first time installation, the display shows the last System ID entered.
3.Press CHNG.
The display shows: -
CLEAR BKSP OK
4.Using the dialpad, enter the System ID number.
Note: If you enter a wrong number, press BKSP to delete the last number entered, or CLEAR to erase all numbers entered.
5.Press OK to accept the System ID number.
This completes general programming. To continue program- ming alarm reporting, refer to the next section, Programming Alarm Reporting.