Nortel Networks FastRad manual Enter password

Page 31

21

Troubleshooting Troubleshooting the FastRAD installation is needed if you start a programming session and the display shows

Inactive feature.

1.Check the wiring at the distribution block.

2.Make sure the Norstar port that the FastRAD is attached to is working.

3.Check that the power LED on the FastRAD unit is lit to confirm the power connection.

4.Refer to the appropriate Norstar Installer Guide for further diagnostic tests.

Note: If the wiring at the distribution block has been discon- nected, the FastRAD can take up to two minutes to reset after the wiring is reconnected.

After you have checked all the wiring:

1.Press ƒ·••. The display should show:

Enter password

EXIT CHNG NEXT

2.Press NEXT.

The display shows:

RAD Admin

 

GEN

ALARM DATA

If the display is still showing Inactive feature, repackage the FastRAD, and return it to the point of purchase.

FastRAD Installation Guide

Image 31
Contents FastRAD Installation Guide Page Table of Contents FastRAD Installation Guide Please Read Carefully Canadian & US Safety Installation InstructionsFor equipment with internal power supplies For equipment with external power suppliesRead and understand all instructions Important Safety InstructionsIndustry Canada Notice Please Read Carefully Canadian RegulationsUS Regulations Address for warranty and repairs in the US FastRAD Regulations FastRAD Installation Guide Pstn Environment check list Package check listNorstar ICS Remote Tools software and documentation package Special check listElectrical RequirementsCTS Requirements for PC communicationConnecting the FastRAD LED Mounting the FastRAD FastRAD Installation Guide Programming the FastRAD Starting a programming session GEN Display showsGeneral Programming Programming Alarm Reporting Clear Retry mins Programming Data Answer delay Press to end programming FastRAD Installation Guide Enter password FastRAD Programming Record Programming RecordDelay FastRAD Installation Guide P0855601 Issue