FastRAD Installation Guide | Nortel Networks FastRad manual

Testing the After the FastRAD installation and on site programming are

FastRAD completed you should test the FastRAD data transfer capabil- ities. To test the FastRAD, make a connection between the PC

running ICSRT and the KSU at the customer site.

If the PC is not located at the customer site and the FastRAD is not programmed with Auto-answer ON, you must phone the ICSRT operator and instruct the operator to establish a connection with the FastRAD. In this case, refer to Rerouting a call to the FastRAD.

If you are using a PC at the work site, refer to ICS Remote Tools

User Guide for instructions about connecting to the RAD.

The test is passed when the remote or local PC establishes a connection with the KSU.

If the FastRAD is programmed to report alarms, you can test alarm calls by disconnecting the FastRAD power supply. After a few seconds, reconnect the power supply. The FastRAD reports an alarm to the specified alarm connection centers.

Rerouting a Call If the FastRAD is not set up to Auto-answer a Central Office

to the FastRAD (CO) line, ask the ICSRT user to set up an operator assisted-call to your site. If the operator-assisted call is not accepted by the

FastRAD, ensure the FastRAD is not involved in a programming session. Then ask the ICSRT user to attempt another operator- assisted call.