Nortel Networks FastRad manual Starting a programming session

Page 21

11

Starting a programming session

The FastRAD cannot be used for remote or direct connections until the user password has been programed through Feature 9**. This initial password programming must occur on-site.

IMPORTANT: There is no way to recover a lost or forgotten password or return to the default state.

A FastRAD is programmed from a Norstar two-line display tele- phone that is connected to the KSU. Programming information is entered into the FastRAD using the dialpad on the telephone. Follow the prompts that appear on the display.

Note: You cannot start a programming session while you are on a call. When a programming session is in progress, press only the buttons indicated. The programming session is termi- nated when you press incorrect buttons or when you make or answer a call. Only on a DR2 KSU can you put the programming session on hold to make or answer a call.

If you need to go back a step while you are programming, press BACK or press ®and start again. If you stop programming for more than three minutes, the display returns to the date and time, and you must restart programming from the beginning.

IMPORTANT: You must wait 60 seconds before you attempt to

program the FastRAD when: the FastRAD is connected or restarted; the power supply is disconnected or the KSU is restarted.

To start a programming session:

1.Press ƒ·••.

The display shows: Password

EXIT CHNG NEXT

Note: When the password has been changed, the display

shows: Enter password. Check the FastRAD installation

wiring and start again if the display shows: Inactive feature. For more information, refer to Troubleshooting, later in this guide.

FastRAD Installation Guide

Image 21
Contents FastRAD Installation Guide Page Table of Contents FastRAD Installation Guide For equipment with internal power supplies Canadian & US Safety Installation InstructionsFor equipment with external power supplies Please Read CarefullyRead and understand all instructions Important Safety InstructionsIndustry Canada Notice Please Read Carefully Canadian RegulationsUS Regulations Address for warranty and repairs in the US FastRAD Regulations FastRAD Installation Guide Pstn Environment check list Package check listElectrical Special check listRequirements Norstar ICS Remote Tools software and documentation packageCTS Requirements for PC communicationConnecting the FastRAD LED Mounting the FastRAD FastRAD Installation Guide Programming the FastRAD Starting a programming session GEN Display showsGeneral Programming Programming Alarm Reporting Clear Retry mins Programming Data Answer delay Press to end programming FastRAD Installation Guide Enter password FastRAD Programming Record Programming RecordDelay FastRAD Installation Guide P0855601 Issue