Nortel Networks FastRad manual Answer delay

18

Note: In general, the following points should be consid- ered while choosing the FastRAD Auto-answer line:

•If possible, use an on-core line for auto-answering. This allows remote access to the KSU even in the event of an expansion module failure.

•Use a line that is not often used for other purposes, since the FastRAD will auto-answer after a pre- programmed delay.

•Choose only lines that are enabled.

6.Press OK.

The display shows:	Answer delay: 18
	BACK	CHNG NEXT

7.Press CHNG to change the number of seconds the FastRAD waits before answering an incoming data call.

The display shows:	Answer delay:_
	CLEAR	BKSP OK

8.Enter the number of seconds you want the FastRAD to wait prior to answering an incoming data call. This number must be between 6 and 60.

Note: The modem “wait for carrier delay” (S Register 7) must be longer than the time it takes for the modem to dial the FastRAD Auto-answer line plus the Answer delay time. For example, if it takes 10 seconds for the modem to dial in to the FastRAD and Answer delay is set to 50 seconds, then the modem “wait for carrier delay” must be greater than 60 seconds.

9.Press OK.

The display shows:	Local baud: 9600
	BACK	CHNG NEXT

FastRAD Installation Guide