AT&T TL74308 Adding and registering handsets, To register a handset to your telephone base

Appendix D

Adding and registering handsets

Your telephone can accommodate up to four cordless handsets. You can add new handsets (TL77008, sold separately) to the TL74108/TL74208/TL74308/ TL74408/TL74258/TL74358/TL74458 at any time, but each new handset must be registered with the telephone base before use. Each handset must be registered separately.

The handset provided with your TL74108 is automatically registered as handset 1. Additional handsets will be assigned numbers in the order they are registered (handset 2, handset 3, and handset 4). You can register a maximum of four handsets.

The TL74208/TL74258 has two handsets automatically registered as handset 1 and handset 2. You can register two additional handsets, which will be assigned as handset 3 and handset 4.

The TL74308/TL74358 has three handsets automatically registered as handset 1, handset 2 and handset 3. You can register one additional handset, which will be assigned as handset 4.

The TL74408/TL74458 has four pre-registered handsets, so you cannot register any additional handsets to it.

Handsets purchased separately need to be registered to NOT REGISTERED the telephone base before use. When first purchased, all

optional accessory handsets will show NOT REGISTERED on the screen. The new handset may need to be charged for five minutes before registering to the telephone base.

PRESS HNDST LOC 4 SEC ON BASE

PLEASE WAIT...

HANDSET X

REGISTERED

To register a handset to your telephone base

1.Place the unregistered handset into a charger. If PRESS HNDST LOC 4 SEC ON BASE does not appear on the handset screen after a few seconds, remove the handset and place it in a charger again.

2.On the telephone base, press and hold HANDSET LOCATOR/INTERCOM for about four seconds (until the red IN USE light on the telephone base turns on) and then release the button. The handset will show PLEASE WAIT... and it will take about 10 seconds to complete the registration. The handset will show HS X REGISTERED and will beep if the registration is successful.

NOTES:

1.If the registration is not successful, the display will show NOT REGISTERED. To reset the handset, remove the handset from the charger and place it back in. Try the registration process again.

2.You cannot register a handset if any other system handset is in use.

68