AT&T TL 74208 This Troubleshooting guide, Please refer to the Battery installation and charging

Appendix L

Troubleshooting

CONNECTING...	•	Ensure that the telephone base is powered up.
displays on my	•	Place the cordless handset in the telephone base for
cordless handset
		one minute to allow the cordless handset and base to
		resynchronize channels.
	•	Move the cordless handset closer to the telephone base.
		You might have moved out of range.
	•	Reset the telephone base. Unplug the unit’s electrical
		power. Wait for 15 seconds then plug it back in.
		Allow up to one minute for the cordless handset and
		telephone base to reset.
	•	Other electronic products can cause interference with
		your cordless phone. Try installing your phone as far
		away from these types of electronic devices as possible:
		television sets, VCRs, or other cordless telephones.
	•	If there is no AC power, even if there are base batteries,
		you may see this display.
The batteries	•	If the cordless handset is in the charger and the charge
will not hold a		light does not come on, refer to The charge light is off
charge		in this Troubleshooting guide.
	•	Charge the battery in the cordless handset for at least
		16 hours. For optimum daily performance, return the
		cordless handset to its base when not in use.
	•	If the battery is depleted, it may take approximately four
		minutes to charge the handset before it can resume
		display on the screen.
	•	You may need to purchase a new handset battery,
		please refer to the Battery installation and charging
		section of this user’s manual.
	•	Your phone might be malfunctioning. Please refer to
		the Limited warranty section of this user’s manual for
		further instruction.
I get noise,	•	If you subscribe to high-speed Internet service (Digital
static, or weak		Subscriber Line - DSL) through your telephone line, you
signal even		must install a DSL filter between the telephone base
when I’m near		and the telephone wall jack (see page 6). The filter will
the telephone		prevent noise and caller ID problems caused by DSL
base		interference. Please contact your DSL service provider
		for more information about DSL filters.

83