Bogen LUMDMU manual Front Panel Operation, Controls and Indicators, Recording Messages

Page 10

Front Panel Operation

The MDMU can record messages input from the front panel through the Hand Set, Tape, and Mic connectors. The unit also record and store messages input remotely through telephone access to the REM port using a DTMF (touch tone) telephone.

Controls and Indicators

FRONT VIEW

			HAND
FUNC	RUN		HAND
FUNC	RUN		SET		TAPE	M I C
			SET		TAPE	M I C

MULTIPLE DIGITAL MESSAGING UNIT

IDLE

F U N C T I O N	FUNCTION	RUN	TAPE	M I C
DISPLAY	S E L E C T I O N	F U N C T I O N	I N P U T	I N P U T
	B U T T O N	B U T T O N

					H A N D S E T
						I N P U T
REAR VIEW

				REM O P T I O N	BATTERY
	AUX. CONNECTOR	J1		REM O P T I O N	BATTERY
				SWITCH	OFF ON

50 PIN RJ-21	M E S S A G E	T E L E P H O N E
C O N N E C T O R	O U T P U T	A C C E S S

O P T I O N	BATTERY	POWER
S W I T C H	S W I T C H	I N P U T

Figure 8 Controls and Indicators.

Recording Messages

The highest priority message should be recorded on the lowest message number (1) to ensure fastest replay (i.e. Fire in Building...).

1	Plug the telephone handset, microphone, or tape
	player into the appropriate connector on the front
	player into the appropriate connector on the front
	panel.

2	Press the (black) FUNC button until the RECORD
	message is displayed.

			RECORD


3	Press the (red) RUN button to display the message
	number #1.

7

Image 10

Contents Multiple Digital Message Unit Domestic and International Approvals Table of Contents Introduction Before You StartInstallation Steps Have Required ToolsConnect the Mdmu to the Telephone System Rack Mounted MdmuMdmu Connection to Over Ride Set the Mdmu options on the DIP switch. Refer to Table belowPower Up System Push the Battery slide switch to the on positionFront Panel Operation Controls and IndicatorsRecording Messages When recording is complete, press the Func key Listening to Recorded Messages Press the RUN button Playing MessagesPress the Func button until Play is displayed Than MSG-01 to playPress the Func button to select a message other You are configured for 8 seePlaying Messages in Sequence Press RUN to play and group the messageAdding a Time Delay Between Message Plays Clearing a Message Sequence Press RUN to clear the message sequenceChecking Message Times Press the Func button until Time appearsReset Delay Times to Default Audio and Memory TestsButton until Test appears Button to end the continuous audioTest Button to select the memory testTelephone Access Operation Playing Messages Specifications On the next page give the Aux. Connector pin-out definitionsPIN Wire Colors Definition Blue White J1 Ring Orange