Bogen LUMDMU manual Reset Delay Times to Default, Audio and Memory Tests

Page 18

Reset Delay Times to Default

The INIT (initialize) function resets the operating parameters and delay time to the default setting of five seconds without effecting the recorded messages.

1 Press the FUNC button until INIT appears.

INIT

2

3

Press the RUN button.

SURE ?

Verification of command.

Press the RUN button again to initialize.

WAIT

DONE

Audio and Memory Tests

Two diagnostics tests are built into the MDMU internal software. The audio test plays a 1000 Hz tone to the installed J1 output line. The memory test clears all recorded messages and internally writes and reads a number of test patterns to verify proper operation.

Audio Test

1

2

3

Press the FUNC button until TEST appears.

TEST

Press the RUN button to display the test options.

AUD TEST

Press the RUN button again to begin the test.

15

Image 18

Contents Multiple Digital Message Unit Domestic and International Approvals Table of Contents Introduction Before You StartInstallation Steps Have Required ToolsConnect the Mdmu to the Telephone System Rack Mounted MdmuMdmu Connection to Over Ride Set the Mdmu options on the DIP switch. Refer to Table belowPower Up System Push the Battery slide switch to the on positionControls and Indicators Front Panel OperationRecording Messages When recording is complete, press the Func key Listening to Recorded Messages Press the RUN button Playing MessagesPress the Func button until Play is displayed Than MSG-01 to playPress the Func button to select a message other You are configured for 8 seePlaying Messages in Sequence Press RUN to play and group the messageAdding a Time Delay Between Message Plays Clearing a Message Sequence Press RUN to clear the message sequenceChecking Message Times Press the Func button until Time appearsReset Delay Times to Default Audio and Memory TestsButton until Test appears Button to end the continuous audioTest Button to select the memory testTelephone Access Operation Playing Messages Specifications On the next page give the Aux. Connector pin-out definitionsPIN Wire Colors Definition Blue White J1 Ring Orange