Bogen LUMDMU manual Mdmu Connection to Over Ride

Page 7

3 Plug the modular cord into connector J1 on MDMU and connect the wires on the other end to the Over Ride terminal.

NOTE: For specific pin-out information for this connector refer to Figure 9 at the end of this guide. Messages 1 through 6 correspond to message starts 1 through 6.

Figure 4. MDMU Connection to Over Ride

4 Connect the RJ-21 cable/connector to the MDMU Aux. Interface and to terminal block.

AUX. CONNECTOR	J1		REM OPTION	BATTERY
			SWITCH	OFF ON
			SWITCH	OFF ON

RJ-21 CABLE AND

CONNECTOR

SCREW LUG

TERMINAL BLOCK

MESSAGE #1

TYPICAL CONNECTION

TO MOMENTARY

CONTACT CLOSURE

TO START MESSAGE

TYPICAL

CONNECTION TO

TERMINAL BLOCK

MESSAGE #6

Figure 5 Connection of RJ-21 Cable to MDMU.

4

Image 7

Contents Multiple Digital Message Unit Domestic and International Approvals Table of Contents Before You Start IntroductionHave Required Tools Installation StepsRack Mounted Mdmu Connect the Mdmu to the Telephone SystemMdmu Connection to Over Ride Table below Set the Mdmu options on the DIP switch. Refer toPush the Battery slide switch to the on position Power Up SystemFront Panel Operation Controls and IndicatorsRecording Messages When recording is complete, press the Func key Listening to Recorded Messages Than MSG-01 to play Playing MessagesPress the Func button until Play is displayed Press the RUN buttonPress RUN to play and group the message You are configured for 8 seePlaying Messages in Sequence Press the Func button to select a message otherAdding a Time Delay Between Message Plays Press RUN to clear the message sequence Clearing a Message SequencePress the Func button until Time appears Checking Message TimesAudio and Memory Tests Reset Delay Times to DefaultButton to select the memory test Button to end the continuous audioTest Button until Test appearsTelephone Access Operation Playing Messages On the next page give the Aux. Connector pin-out definitions SpecificationsPIN Wire Colors Definition Blue White J1 Ring Orange