Bogen LUMDMU manual Clearing a Message Sequence, Press RUN to clear the message sequence

Page 16

Clearing a Message Sequence

1

2

3

4

The message sequence can be cleared leaving the individual messages to be played separately.

Press the FUNC button until PLAY is displayed

PLAY

Press the RUN button.

MSG-01

Press the FUNC button until the following message is displayed.

MSG-00

This is the message abort number.

Press RUN to clear the message sequence.

CLEARED

DONE

IDLE

13

Image 16

Contents Multiple Digital Message Unit Domestic and International Approvals Table of Contents Introduction Before You StartInstallation Steps Have Required ToolsConnect the Mdmu to the Telephone System Rack Mounted MdmuMdmu Connection to Over Ride Set the Mdmu options on the DIP switch. Refer to Table belowPower Up System Push the Battery slide switch to the on positionFront Panel Operation Controls and IndicatorsRecording Messages When recording is complete, press the Func key Listening to Recorded Messages Playing Messages Press the Func button until Play is displayed Press the RUN button Than MSG-01 to playYou are configured for 8 see Playing Messages in SequencePress the Func button to select a message other Press RUN to play and group the messageAdding a Time Delay Between Message Plays Clearing a Message Sequence Press RUN to clear the message sequenceChecking Message Times Press the Func button until Time appearsReset Delay Times to Default Audio and Memory TestsButton to end the continuous audio TestButton until Test appears Button to select the memory testTelephone Access Operation Playing Messages Specifications On the next page give the Aux. Connector pin-out definitionsPIN Wire Colors Definition Blue White J1 Ring Orange