Bogen LUMDMU manual Telephone Access Operation

Page 20

Telephone Access Operation

The MDMU may be accessed remotely using a DTMF (Touch Tone) telephone. Telephone access can be made directly through a telephone switching system with one of its analog stations connected to the MDMU REM port.

Recording Messages

1	Dial the telephone extension of the MDMU.

2	Press ✽ 7 (R for record) and the message number.
	(for example, ✽ 76 - record message number 6)

3	When you hear the beep, begin recording the
	message.

4	Optionally, to send this message to a particular
	paging zone, dial the zone number
	now, then continue recording this message.

5

6

Press the # keys to end recording and save message.

Press the # key again to disconnect from the MDMU.

Listening to Recorded Messages

1	Dial the telephone extension of the MDMU.

2	Press ✽ 6 (M for monitor) and the message number.
	(for example, ✽ 609 - monitor message number 9)

Press the # key to end monitoring message.

Press the # key again to disconnect from the MDMU.

17

Image 20

Contents Multiple Digital Message Unit Domestic and International Approvals Table of Contents Introduction Before You StartInstallation Steps Have Required ToolsConnect the Mdmu to the Telephone System Rack Mounted MdmuMdmu Connection to Over Ride Set the Mdmu options on the DIP switch. Refer to Table belowPower Up System Push the Battery slide switch to the on positionRecording Messages Controls and IndicatorsFront Panel Operation When recording is complete, press the Func key Listening to Recorded Messages Playing Messages Press the Func button until Play is displayedPress the RUN button Than MSG-01 to playYou are configured for 8 see Playing Messages in SequencePress the Func button to select a message other Press RUN to play and group the messageAdding a Time Delay Between Message Plays Clearing a Message Sequence Press RUN to clear the message sequenceChecking Message Times Press the Func button until Time appearsReset Delay Times to Default Audio and Memory TestsButton to end the continuous audio TestButton until Test appears Button to select the memory testTelephone Access Operation Playing Messages Specifications On the next page give the Aux. Connector pin-out definitionsPIN Wire Colors Definition Blue White J1 Ring Orange