Bogen LUMDMU manual When recording is complete, press the Func key

Page 11

NOTE: Depending on number of messages optioned during installation (switch 7), the (available message numbers will read 1 through 9, or 01 through 99.

NOTE: If the message number selected has been pre-recorded, a messaged will display "SURE?" Press "RUN" again to append to the existing message.

During recording, the display will show the amount of memory remaining for the unit in minutes and seconds.

NOTE: While recording a message, pressing RUN will pause the recording. Press RUN again to continue.

4 To record on another message number, press the FUNC key until the desired message number appears.

5 Press the RUN button and begin speaking into the handset, microphone, or press play on the tape player.

SURE ?


				mm:ss


6	When recording is complete, press the FUNC key.
		The display shows the amount of time
		used for the message:


				TIME



			0:30


				DONE


				IDLE


7	Repeat steps 2 through 6 to record other messages.

8

Image 11

Contents Multiple Digital Message Unit Domestic and International Approvals Table of Contents Before You Start IntroductionHave Required Tools Installation StepsRack Mounted Mdmu Connect the Mdmu to the Telephone SystemMdmu Connection to Over Ride Table below Set the Mdmu options on the DIP switch. Refer toPush the Battery slide switch to the on position Power Up SystemRecording Messages Controls and IndicatorsFront Panel Operation When recording is complete, press the Func key Listening to Recorded Messages Than MSG-01 to play Playing MessagesPress the Func button until Play is displayed Press the RUN buttonPress RUN to play and group the message You are configured for 8 seePlaying Messages in Sequence Press the Func button to select a message otherAdding a Time Delay Between Message Plays Press RUN to clear the message sequence Clearing a Message SequencePress the Func button until Time appears Checking Message TimesAudio and Memory Tests Reset Delay Times to DefaultButton to select the memory test Button to end the continuous audioTest Button until Test appearsTelephone Access Operation Playing Messages On the next page give the Aux. Connector pin-out definitions SpecificationsPIN Wire Colors Definition Blue White J1 Ring Orange